datum curve length

Status
Not open for further replies.

SCOT GREER

Usenet Archive
Joined
Dec 2, 2001
Messages
56
Reaction score
0
can i define a datum curves length.........i.e. its a spline it measures 486mm and I want it to be 525, how do I dimension this

thanks Scot
 
sorry I failed to say I am using 2000i
"SCOT GREER" wrote:

can i define a datum curves length.........i.e. its a spline it measures 486mm and I want it to be 525, how do I dimension this

thanks Scot
 
If you have behavioral modeling, then create an Evaluate Feature, that measures the length. Make sure to create a paramter that also equals this length. In Optimization, select to make the total length equal your 525 value by modifing the range of a spline dim.

Run the Optimization until you reach 525mm.

Steve
 
Scot,

I am not sure of the picks in 2000i, but you should be able to find it in the help by looking for Perimeter Dimensions.

In 2001, you create a dim to the endpoints of the spline, select the spline, then pick Edit/Convert To/Perimeter. Next you pick the dimension and it switches over to a perimeter dim, which is the curve length.

I mentioned how it's done in 2001 in case it might help you figure out what command names you need to look for in 2000i.

-Jon

"SCOT GREER" wrote:

sorry I failed to say I am using 2000i
"SCOT GREER" wrote:

> can i define a datum curves length.........i.e. its a spline it measures
> 486mm and I want it to be 525, how do I dimension this
>
> thanks Scot
>
>
 
This is another great way to do this aside from the perimeter dimension i mentioned in my other post, but you don't need behavioral modelling to use the evaluate feature. In 2000i, it's under create/datum/evaluate. in 2000i2 and above, you have to add a config option: anatomic_features yes to get the functionality "back"...then in 2000i2, it'll be under the datum menu at the top. in 2001, under insert/datum at the top.

For some reason, ptc took a lot of features from 2000i and removed them from the menus unless you turn on this config option. it's turned off by default. take a look at the tweak features menu with and without that option. that's where most of the remved features are...amazing how much stuff it removes.

-Jon

"SteveR" wrote:

If you have behavioral modeling, then create an Evaluate Feature, that measures the length. Make sure to create a paramter that also equals this length. In Optimization, select to make the total length equal your 525 value by modifing the range of a spline dim.

Run the Optimization until you reach 525mm.

Steve
 
Status
Not open for further replies.

Latest threads

Back
Top