DASH NUMBERS IN THE BILL OF MATERIALS

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by MANNY_G, Jan 5, 2007.

  1. MANNY_G

    MANNY_G Guest

    Hi

    I need to show in the final assy BOM xxxxx-01,xxxxx-02,xxxxx-03thru
    xxxxx-10 of a sub assy... the dash numbers are in the browser but do
    not show as seperate lines in the BOM. The BOM shows qty 10 for xxxxx.
    I would like to see qty 1 for xxxxx-01,qty 1 for xxxxx-02,qty 5 for
    xxxxx-03 and so on.

    Thanks for the help
    M.G.
     
    MANNY_G, Jan 5, 2007
    #1
    1. Advertisements

  2. MANNY_G

    David Janes Guest

    It sounds like the dash numbered items are components of an assembly. If
    that's the case, then you just need to mess around with the Repeat Region
    properties. So do 'Table>Repeat Region>Attributes' and change from Flat to
    Recursive. See if this doesn't solve your problem.

    David Janes
     
    David Janes, Jan 6, 2007
    #2
    1. Advertisements

  3. MANNY_G

    SAI Guest

    sai krishna reddy:

    if u have sub assemblies in u r bom go to "table-repeat
    region-filters"
    filters means it delete sub modules of bom.
     
    SAI, Jan 17, 2007
    #3
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.