Custom Hole Wizard Depths

Discussion in 'SolidWorks' started by lentzmm, Mar 7, 2007.

  1. lentzmm

    lentzmm Guest

    I'm working on custom hole standards, derived from the ANSI metric
    database. I would like to change the default end conditions (both tap
    drill depth and thread depth), but cannot find where these are
    controlled. I'm working in SW2007, SP2.2

    Thanks,
    Mike
     
    lentzmm, Mar 7, 2007
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.