Create custom standard not working properly?

Discussion in 'SolidWorks' started by Brian Mears, Sep 18, 2004.

  1. Brian Mears

    Brian Mears Guest

    I'm attempting to create a custom standard for my company that is derived
    from Ansi Inch. It doesn't seem to be working properly. First, when using
    the hole wizard, I'm only able to see metric sizes. Also, some of the
    choices (such as Fractional Drill Sizes) are not available, even though they
    are NOT disabled in the standard. What gives? Am I doing something wrong,
    or is something else going on? Thoughts? Thanks.

    Brian
     
    Brian Mears, Sep 18, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Programming Mouse Buttons - Not working properly

  2. Vlide not loading nested defuns properly?

  3. Why does a procedure not get properly evaluated with montecarlo?

  4. SW has not been commisioned properly

  5. SW2004 shaded views w/surfaces not working properly!!

  6. Weld Symbols are not working properly!

  7. block delete method not working properly

  8. Plotter Configuration Editor not properly set up

Loading...