Corner tool: How to reset / delete measurement list?

Discussion in 'Cadence' started by Svenn Are Bjerkem, Nov 2, 2004.

  1. Svenn Are Bjerkem

    Svenn Are Bjerkem Guest

    Hi,
    When starting the corner tool from ADE, it gets the outputs to plot from
    the "outputs to be plotted" in ADE. It also get the technology from the
    "Model Setup". I have to manually delete the outputs that I don't want
    to have in my plotted corner run. If I save my setup to a dcf, the
    corner tool does not delete the unwanted signals when I reread the dcf
    file, but it *adds* them to the existing. After deleting the signals
    manually, which is a pain as I can't select more signals and then press
    delete, corner tool behaves nicely until next start of ADE. Then it is
    the same over again.

    Is there a "wipe my brain" skill command for corner tool that I can
    include at the top of the dcf file?

    Kind regards,
     
    Svenn Are Bjerkem, Nov 2, 2004
    #1
  2. Svenn Are Bjerkem

    Svenn Are Bjerkem Guest

    Funny that I should ask. The command is called corDeleteAllMeas(), but
    it does not survive a save or a save as, so a handcrafted dcf must
    always stay handcrafted.
     
    Svenn Are Bjerkem, Nov 2, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. How do I reset layer info after running a routine?

  2. list c = list a - list b?

  3. When the corner tool and sequence of measurement statements

  4. ADE corner tool does not start up in VNC

  5. Linked Spreadsheet - how to reset path?

  6. bug in measurement tool SW2005

  7. Break Corner vs Corner Trim

  8. How to make a distance measurement continuously?

Loading...