Converting a SPICE model to a .dml file in SpecctraQuest SI

Discussion in 'Cadence' started by jc_webs, Feb 21, 2006.

  1. jc_webs

    jc_webs Guest

    Hi,
    I'm using Cadence SpectraQuest SI 15.5 to do Post Simulation of a PCB
    layout. The layout was done in Allegro. I have ibis files for most of
    the ICs on the PCB and I can convert these files to a .dml in
    SpecctraQuest and perform the SI for reflections ok. But one of the ICs
    on the PCB only has a SPICE model. I am trying to figure out how to
    convert the SPICE model of this IC to a dml file. Although the help
    talks about spice2dml conversion files I cannot figure out exactly how
    to do this. I am running on a PC in a windows XP environment. Any help
    greatly appreciated.
    jc
     
    jc_webs, Feb 21, 2006
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. converting Hspice tech file to spectre tech file

  2. Using Cadence Specctraquest with a layout done in Orcad Layout Plus

  3. Converting synthesized VHDL/Verilog to spice netlist

  4. Specctraquest

  5. Spice model to check the status of internal signals

  6. Use Spice model in Cadence

  7. 90nm model for Spice

  8. converting a cbt file to a pc3 file

Loading...