checkerplate hatch pattern...

anyone have one...

 

HatchMaker didn't cut it, huh?

 

i could not get the pattern correct... the program worked fine, i just
could not get the correct pattern...

 

and the pattern looks like...?

(I can't picture a checkerplate)
-doug

 

If by "checkerplate" you mean what I would call "diamond-plate," I have two:

*DIA-PL-1,Diamond-Plate, 1", 45 deg., Single-Line for smaller scales
45,-0.265165,-0.265165,1,1,0.75,-1.25
135,0.9722718,0.4419418,1,1,0.75,-1.25
*DIA-PL-2,Diamond-Plate, 1", 45 deg., Double-Line for larger scales
63.434947,0.1031197,-0.1031197,1.264911,0.6324556,0.4611655,-2.7011122
63.434947,-0.3093592,-0.3093592,1.264911,0.6324556,0.4611655,-2.7011122
26.565053,-0.3093592,-0.3093592,1.8973666,0.6324555,0.4611655,-2.7011122
26.565053,-0.1031197,0.1031197,1.8973666,0.6324555,0.4611655,-2.7011122
333.434947,0.6039871,0.6039871,1.264911,0.6324556,0.4611655,-2.7011122
333.434947,0.3977476,1.016466,1.264911,0.6324556,0.4611655,-2.7011122
296.565053,0.3977476,1.016466,1.8973666,0.6324555,0.4611655,-2.7011122
296.565053,0.8102265,0.8102265,1.8973666,0.6324555,0.4611655,-2.7011122

If you want something that looks like a Checkerboard, I have this that might
work for you:

*CHECKER,Square grid, Every Other Square shaded
0,0,0,0,1
90,0,0,0,1
0,0,.1,0,2,1,-1
0,0,.2,0,2,1,-1
0,0,.3,0,2,1,-1
0,0,.4,0,2,1,-1
0,0,.5,0,2,1,-1
0,0,.6,0,2,1,-1
0,0,.7,0,2,1,-1
0,0,.8,0,2,1,-1
0,0,.9,0,2,1,-1
270,-.1,0,0,2,1,-1
270,-.2,0,0,2,1,-1
270,-.3,0,0,2,1,-1
270,-.4,0,0,2,1,-1
270,-.5,0,0,2,1,-1
270,-.6,0,0,2,1,-1
270,-.7,0,0,2,1,-1
270,-.8,0,0,2,1,-1
270,-.9,0,0,2,1,-1

Kent Cooper, AIA


...

 

diamond plate... yes, 10-4... thank you...