Centerline tool not recognizing mirrored cylindrical features

Discussion in 'SolidWorks' started by Wayne Tiffany, Dec 2, 2004.

  1. Wayne Tiffany

    Wayne Tiffany Guest

    I can't quite picture what you are talking about, but it would make some
    sense that the centerline would react to the feature, and only as far as the
    end of the feature, if the mirror didn't join it all together.

    WT
     
    Wayne Tiffany, Dec 2, 2004
    #1
  2. Wayne Tiffany

    CS Guest

    I have a few swept parts in the job I am working on currently. I noticed
    that when using the centerline tool it only adds centerlines to half of the
    part, and the half of the part that was the origional sweep. The other side
    of the part is a mirror of the first and doesn't get recognized.
    SW 2004 sp4.2 could anyone verify if this behavior is consistent in 2005.

    Corey
     
    CS, Dec 2, 2004
    #2
  3. Wayne Tiffany

    CS Guest

    |_____|
    picture a bar as shown above.
    The right side of it was sketched and swept.
    The left side of it was a mirror of the right, and the result was merged
    drop in a drawing and the right side only gets the Centerlines when applied
    to the view.

    Corey
     
    CS, Dec 2, 2004
    #3
  4. Wayne Tiffany

    Krister L Guest

    Acts just the same in 2005 Sp0.1

    Krister L
     
    Krister L, Dec 3, 2004
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. if statement not recognizing variable setting

  2. Recognizing SKILL based layouts?

  3. LVS not recognizing poly cap

  4. normal cut on cylindrical thin wall (NOT sheet metal)

  5. non mirrored text in mirrored blocks

  6. Acad not recognizing Adobe ?

  7. Not recognizing pen style

Loading...