Cadence Spectre and Virtuso on RedHat Linux 9.0

Discussion in 'Cadence' started by Nathan, Jan 26, 2004.

  1. Nathan

    Nathan Guest

    I am following up on my earlier message dated Fri, 16 Jan 2004 16:32:06
    GMT which was

    " We are having difficulty installing Cadence 5.0 on Redhat Linux 9.0.
    Cadence recomments 7.2 but we have hardware issues with 7.2.
    Has anybody got it to work on 9.0 ? "

    Here is the error message I am getting.
    "Incorrectly built binary which accesses errno, h_errno or _res
    directly. Needs to be fixed."

    Has anybody seen this problem and is there a way to overcome this in
    Redhat 9.0 ?


    Nathan, Jan 26, 2004
  2. Nathan

    B Guest

    Normally, this message should NOT prevent you from installing nor
    from using the software. If you cannot install it, it is because
    of other problems and not because of the warning that you getting.

    Unless Cadence compile it in the 9 env, you'd always see this message.
    You just ignore it and go ahead. Other work around has been already
    suggested to you.

    B, Jan 26, 2004
  3. Nathan

    Nathan Guest

    Thanks for you suggestions. I am able to run Cadence although the error
    message still exists.
    Like you said it does not seem to affect the program itself. I have only
    tested it in the read mode so far.
    I tried setenv LD_ASSUME_KERNEL 2.4.1 and LANG C. That did not help.

    Nathan, Jan 27, 2004
  4. Nathan

    B Guest

    To get help, you'd tell us what error message you are getting or what is not
    working exactly. Just describe what you're doing and cut and paste the
    B, Jan 27, 2004
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.