Built In Mold Flow in SWks 2005

Discussion in 'SolidWorks' started by Bonobo, Jul 18, 2005.

  1. Bonobo

    Bonobo Guest

    I've used the built in mold flow to analyze a few parts I've done in
    the past and though the fill image is anything but smooth, the general
    fill patern seems to be close to what is observed in my molds. It has
    given me a bit more confidence in trying the built-in mold flow with
    new, and slightly more complex parts. I have seen notes about the
    'part is too complex' or similar in dialog boxes, but the flow front
    seems to be reasonable from my experience.

    Given the limitations of the simple or 'crippled' type of mold flow in
    SWks 2005, what have other users thought of it in accuracy of the melt
    flow front for initial filling estimates?

    I didn't find any discussion of this in the recent past.

    Bo
     
    Bonobo, Jul 18, 2005
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.