Bend Allowance Table

Discussion in 'SolidWorks' started by SWManiac, Nov 23, 2010.

  1. SWManiac

    SWManiac Guest

    The Solidworks Bend Allowance table is set for 90 degrees only, how
    can I automate it to be used in a 0.25 or less increment angle up
    from .5 thru 359.5 degrees, also I like to use all different thickness
    steel plates...


    Thanks for any help.
     
    SWManiac, Nov 23, 2010
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Design table generated assembly does not stick to its table parameters inside another assembly

  2. Bend Allowance - Formula

  3. Bend table for drawing, what does your company do?

  4. Bend Allowance

  5. Gauge Table & Design Table

  6. Drawing table values linked to values in design table?

  7. TABLE:copy cell with references to another table

Loading...