all around symbol

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by meme, Feb 25, 2010.

  1. meme

    meme Guest

    is it possible to add the all around symbol on to an arrow or a radius
    dimenion arrow?

    Thanks
    meme
     
    meme, Feb 25, 2010
    #1
  2. meme

    Janes Guest

    is it possible to add the all around symbol on to an arrow or a radius
    dimenion arrow?

    Thanks
    meme
    weld symbols do this all the time, so it looks like you're actually talking about a custom symbol. anything a dimension or note can do is contained in the Properties page... and no 'all around' there. leaving you with door 'b' (draft entities associated with dimensions or note leaders), i.e. 'draw' a circle and place...etc, kludge junk crap 'workaround' etc. sorry, it's Pro/e (and no Dashboard for drawing 'mode', i.e. no improvement in decades--yes, two, so far.)

    David Janes
     
    Janes, Feb 26, 2010
    #2
  3. meme

    meme Guest

    Thanks, I had hoped that there was some change but guess not.
     
    meme, Mar 2, 2010
    #3
  4. meme

    Janes Guest

    is it possible to add the all around symbol on to an arrow or a radius
    dimenion arrow?

    Thanks
    meme
    i had another thought: some geometric tolerances do 'all around', for example, the profile tolerance. Maybe what you're trying to achieve calls for geometric tolerancing.

    David Janes
     
    Janes, Mar 13, 2010
    #4
  5. meme

    Lehnsherr Guest

    Hi, All:

    I found an answer. This is a Wildfire 4 procedure:

    "Insert", "Geometric Tolerance..."
    "Surface Profile" [choose the symbol] ["All Around" pretty much can
    only be used with this GTOL]
    "Reference Selected": "Surface" [select the desired surface edge-on.
    Do not select a surface that is facing you.]
    "Placement": "With Leader", "On Entity", "Arrow Head"
    "Select Surface" [same edge as before]
    "Done"
    "Flip Direction" [little window -- if the yellow arrow is pointing
    away from your surface, click 'OK'.]
    "Select placement location" is indicated in the feedback window...
    click to put the GTOL frame where you want it.
    "Symbols" tab in the GTOL construction window: "All Around" symbol
    appears. Click it. There you go!
     
    Lehnsherr, Mar 29, 2010
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.