about BLEND command inside PRO/E WF

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by edoardo fiorani, Dec 16, 2004.

  1. I'm a beginner in PRO/E WILDFIRE.I'm learning how buiding up complex
    geometries using the command BLEND.I draw the sections but all the time i
    can't go on and an error message appears on the screen:"Only one loop per
    subsection is allowed".I know that the problem is "silly",but please
    understand my first difficulties.
    Edoardo.
     
    edoardo fiorani, Dec 16, 2004
    #1
  2. Dzenkuje bardzo.......
    na raze
    edoardo
     
    edoardo fiorani, Dec 16, 2004
    #2
  3. edoardo fiorani

    kenny Guest

    Just out of interest, what are the job opportunities for proe users in
    Poland?
    pozdrowienia
     
    kenny, Dec 17, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.