_snap _rot - getcorner problem

Discussion in 'AutoCAD' started by gert, Feb 10, 2005.

  1. gert

    gert Guest

    I would like to make a (getcorner orthogonal to my through
    (command "_.SNAP" "_ROTATE"
    rotated crosshair, to mark an area orthogonal to a selected line.
    is this possible?
    The (getcorner seems to be always in "north-south" orientation

    MfG
    Gert
     
    gert, Feb 10, 2005
    #1
  2. gert

    Kent Cooper, AIA Guest

    You could rotate the UCS to align with the line instead of rotating the Snap
    angle. Have UCSFOLLOW turned on so it rotates the view. Then do whatever
    it is that uses (getcorner). Then reset the UCS.
     
    Kent Cooper, AIA, Feb 10, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Special Hatch Problem

  2. UCS Direction problem.

  3. Entmake 3D Polyline Problem without attachment

  4. strcat problem

  5. (dos_getfiled) problem with acad2000

  6. Is this a variable problem?

  7. Error Problem - Plotting Problem

  8. Error Problem - Plotting Problem

Loading...