device parameters not showing up on devices after simulation annotation

Discussion in 'Cadence' started by Poojan Wagh, Sep 5, 2006.

  1. Poojan Wagh

    Poojan Wagh Guest

    Hi, cadence experts.

    I have a mostly basic problem that has been bugging me. Normally, when
    I open up a schematic, my device parameters (width, length, m-factors,
    etc.) show up next to the device. If I run spectre (for example) and
    choose results->annotate->device parameters, I can get currents, etc.
    to show up. However, after running these sims and going back to
    results->annotate->design defaults, all my parameters disappear.

    Is there any way to get back, to the original annotations (other than
    quitting & restarting icfb)?
     
    Poojan Wagh, Sep 5, 2006
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.