Any method to draw a 45 degree path?

Discussion in 'Cadence' started by Tao Chen, Jul 2, 2004.

  1. Tao Chen

    Tao Chen Guest

    Hi,

    I am drawing layout now. To draw the connections with "path" command
    is quite efficient. But I cannot use it to draw a 45 degree wire in
    order to avoid offgrid errors. Does anybody know other efficient way
    to draw a 45 degree wire? Thanks!

    Tao
     
    Tao Chen, Jul 2, 2004
    #1
  2. Tao Chen

    Jim Newton Guest

    VCAD has a tool to generate ongrid 45 degree paths.
    please contact
     
    Jim Newton, Jul 2, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Error using WSH Run method with long path names

  2. create path in 45 degree -- off-grid in the corner points?? VLE

  3. Paths ending with 90 Degree bend less than 1/2 width long problem

  4. 90 Degree Corner check

  5. Is there any method to get the id of newly created path????

  6. Any one in here draw drill bits, or reamers

  7. Any method to fix up and down when rotating

Loading...